WOJTEK GAS BLOCK INSTALLATION INSTRUCTIONS

  • 1)

    Do not use anything but an allen wrench to tighten the clamping screws. Do not tighten any more than hand tight or snug. Once properly attached you will not have any problems. In fact, you're going to have to try to have problems.

  • 2)

    Space the gas block off the gas journal with a credit card. This will give you the proper offset required for the gas port hole to be aligned with the standard gas port location. All of my blocks now have a witness hole for greater ease of locating the gas port so use that hole if you can.

  • 3)

    To adjust the block, loosen the side locking screw and start with the gas port in the closed position (adjustment screw turned in clockwise) and then turn the adjustment screw gradually open (counter-clockwise) until your rifle reliable cycles. Add an extra 1/4-1/2 turn to the block once your standard of reliability has been achieved and lock the adjustment screw into place with the side locking screw.

If there are any questions or doubts you can always email me at nathan@wojtekweaponry.com. I am pretty quick on the draw for responding to my customers and I will happily resolve any questions you may have.

Have fun out there!

-N8

WE ARE WORKING AND OPEN
Company Info
CONTACT INFORMATION

Mailing Address:

GlockRails
373 S Willow St #249
Manchester, NH 03103